Cannabinoid Purity (TLC) Multi-Use Test Kit

Cannabinoids Test Kit includes best testing liquid and accessories for CBD and THC but also suitable for THCV, CBC, CBG, CBN and more. It is used to discover full number and amount (%) of all phytocannabinoids and to rule out synthetic cannabinoids or different, less predictable, less desirable, highly toxic dangerous drugs. Additional multi-reagent test kit is required to identify ingredients and increase analysis precision.

TLC purity test kits can detect NUMBER and AMOUNT of substances, but not their TYPE.

Cannabinoid Purity Test Kit includes instructions, gloves, 4 vials, 5 testing “cards”, jar, pipette, testing liquid (40 ml), 20 glass tubes, UV-C flashlight (4 AA batteries required, not included) and concentration % rulers for CBD and THC. Each 1 “card”, 4 glass tubes and 6 ml of testing liquid equal 4 tests. Testing “card” can be reused until fully used. Glass and metal protect testing liquid from air and moisture to ensure prolonged shelf life. High-quality caps and lid guarantee 0 spills. 

TLC test kit for cannabinoids includes 1 Cannabinoid Testing Liquid for THC, THCV, CBD, CBC, CBG and CBN. It is best to use this test kit for plants, extracts or other cannabis products.

1. Prepare your testing tools
First, prepare a clean and well-lit area for testing. Prepare the sample, spatula, gloves, plastic bottle, test liquid, pipette, pencil, glass tube, rolled up testing cards, jar and UV-C flashlight. Then, carefully holding the test 'card' by the top edges only, mark 4 points 1 cm apart from the bottom, sides and each other.

2. Prepare the sample
If you are testing tablets, powders or crystals, crush them finely. Weigh the sample in a plastic vial and dissolve it in the test liquid using the proportions given in the instructions. Shake well to dissolve. Too large or too small a sample may lead to inaccurate results.

3. Pour 1 microliter on the card
If there is any sediment, wait a minute for it to settle. Dip the end of the glass tube to fill it with the dissolved sample. Gently touch one of the marked points on the test card to release the sample and mark the spot with a pencil.

4. Put the card in the jar
Add 2 ml of test liquid to the jar and carefully place the white side of the test card in the jar, making sure that it does not touch the sample. Close the jar and observe for about 25 minutes until the test card is almost completely absorbed. Remove the test card from the jar and allow it to dry.

5. Compare results
Use a UV-C flashlight to check your results. The UV-C flashlight will show the spots on the test card under UV-C light, circled with a pencil. Each spot indicates a different substance.

Psychoactive substance test kits contain toxic and/or corrosive chemicals that can burn skin and clothing. Keep away from eyes or mouth; Keep away from children and animals; Always use in a well-ventilated area; Wear gloves and safety goggles; Never point at face or other parts of body. If test materials get on skin and/or clothing, wash immediately with plenty of water and soap; Store reagents in a cool and dark place; The accuracy of reagents will deteriorate over time or due to exposure to air, especially if exposed to sunlight or if stored outside the refrigerator. If you are in doubt about the accuracy of a reagent, test it on a sample that has already been validated.